Two PIA Planes Escape Collision

Two PIA Planes Escape Collision

Two Pakistan International Airlines Aircraft Avoided A Midair Collision

Due to their shared route and altitude, two Pakistan International Airlines aircraft avoided a midair collision on Sunday over Iranian territory close to United Arab Emirates (UAE) airspace. 

The two aircraft allegedly came dangerously close to colliding because of the Iranian Air Traffic Control (ATC), which is claimed to have cleared the same height. A PIA Boeing 777 was flying from Islamabad to Dubai, and an Airbus A320 was flying from Doha to Peshawar, according Pakistani reports. 

While captain Athar Haroon piloted a Boeing 777, captain Samiullah was in command of an Airbus A-320. 

But as the two planes drew nearer, one was ordered to ascend and the other to drop in accordance with protocol. 

Read More | Army To Ensure Security, Hunt Down Terrorists

Read More | Shehbaz Reiterates Commitment To Achieving SCO Goals 

All aircraft have a mechanism called the Traffic Collision Avoidance System (TCAS). By interacting with the TCAS of other aircraft, it automatically pilots the plane. 

“PIA is writing to Iranian air traffic control (ATC) to investigate as the Iranian ATC commanded the jet, but it was wrong,” a PIA spokesman said. 

Boeing 777 From Islamabad To Dubai

According to him, PIA flight (PK-211), a Boeing 777 from Islamabad to Dubai, was flying at 35,000 feet as it approached PIA aircraft (PK-268) from Doha, an Airbus A320 with a destination of Peshawar. He stated that the PK-268 flight was at a height of 36,000 feet and had been given permission to drop to 20,000 feet. 

The Boeing 777 PK-211 PIA jet’s flight path would have been crossed by the descent, the official continued. 

But, he said, the aircraft’s TCAS automatically guided both planes and corrected their courses.

Vinkmag ad

Read Previous

Army To Ensure Security, Hunt Down Terrorists

Read Next

Power Tariff Surges By Rs3.5 After Cabinet Approves ‘Rebasing’

Leave a Reply

Your email address will not be published. Required fields are marked *